Temperature And humidity Controller For Grow Room ZM-T

Our Grow Room Temperature and Humidity Controller
It is mainly used to regulate and control the temperature and humidity inside equipment such as medium and high-voltage switchgear, terminal boxes, ring main units, and pad-mounted substations.
It effectively prevents equipment failures caused by low or high temperatures, as well as creepage and flashover accidents triggered by humidity or condensation.

Advantages

1. High-precision temperature control capability
2. Flexible temperature control mode switching
3. On-demand start/stop, reducing energy waste
4. Intelligent load adaptation, optimizing energy consumption curves
5. Multiple protections to avoid abnormal risks
6. Strong anti-interference ability and environmental adaptability
7. High usability with a low learning threshold
8. Expandable and linkage control support

• Temperature And humidity Controller For Grow Room Technical Parameters

• Power Supply Voltage	(Default product power supply is AC220V, 50 - 60Hz) DC (customizable): 24V, 36V, 48V, 110V, 220V
  Measurement Accuracy	Temperature: ±0.3°C; Temperature Resolution: 0.1°C; Humidity: ±2%RH; Humidity Resolution: 0.1%
  Measurement and Control Range	Temperature: - 30~+100°C; Humidity: 0~100%RH
  Display Method	Measured value and set value displayed by nixie tubes; Output status and control mode indicated by LED lights
  Control Mode	Heating and Humidifying 1 - 1:	Start when the temperature is ≤ (set value), and stop when the temperature is ≥ (set value + hysteresis).
  		Start when the humidity ≤ (set value), and stop when the humidity ≥ (set value + hysteresis).
  	Cooling and Dehumidifying 0 - 0:	Start when the temperature is ≥ (set value) and stop when the temperature is ≤ (set value - hysteresis).
  		Start when the humidity is ≥ (set value) and stop when the humidity is ≤ (set value - hysteresis)
  	Heating and Dehumidifying 1 - 0:	Start when the temperature is ≤ (set value), and stop when the temperature is ≥ (set value + hysteresis).
  		Start when the humidity is ≥ (set value), and stop when the humidity is ≤ (set value - hysteresis).
  	Cooling and Humidifying 0 - 1:	Start when the temperature is ≥ (set value) and stop when the temperature is ≤ (set value - hysteresis).
  		Start when the humidity is ≤ (set value) and stop when the humidity is ≥ (set value + hysteresis).
  Control Output	Relay manual/automatic output: Contact capacity 250VAC 5A (resistive load)
  Installation Method	Panel - embedded installation, base - type installation (with installation standard guide rail base)	Panel - embedded installation, base - type installation (with installation standard guide rail base)
  Installation Dimensions	45x45mm	45x45mm
  Others	Insulation Resistance: >100MΩ
  	Insulation Strength: 2000VAC for 1 minute
  	Power Consumption: <2VA
  	Operating environment: Occasions with non - corrosive gas, where the temperature is 0 - 50°C and the relative humidity is 30 - 95% RH.

  WordPress Table

• Outline and Installation Dimensions

• Outline Code	4	5	A	6	9	2
  Outline Dimensions	48×48	48×96	72×72	80×80	96×96	120×120
  Mounting Hole Dimensions	45×45	45×91	67×67	76×76	91×91	111×111
  Description	Micro - square	Flat - square	72 - square	80 - square	96 - square	120 - square

  WordPress Table